Charcoal and Tea Tree Soap with Tamanu Oil

Doesn't that bubble look like a beetle with enormous eyeballs?

I have made soap once, so, I was afraid to make this soap, Activated Charcoal Soap, especially after seeing all the comments about some fails underneath the post on Soap Queens Blog.  You can access that post here.

I bought some activated charcoal a year or so ago.  I have a lot of it.  We have used it a few times for tummy aches and let me tell you, it works like a charm.  It's bizarre though to eat something black, takes some getting used to.  I just mix a teaspoon or two with a little bit of applesauce.

I changed it up just a wee bit and added some peppermint oil.  It smells so good!  I am pretty excited about the outcome, isn't it a beautiful soap?

Charcoal and Tea Tree Soap with Tamanu Oil
This is the recipe I used, please see Soap Queens recipe here.

1.8 oz. Castor Oil (5%)

9 oz. Coconut Oil (25%)

14.4 oz. Olive Oil (40%)

9 oz. Palm Oil (25%)

1.8 oz. Tamanu Oil (5%)

5.1 oz. Sodium Hydroxide Lye

10.1 oz. Distilled Water (15% water discount) 

1.7 oz. Tea Tree Essential Oil and Peppermint Essential Oil combination

2 tablespoons activated charcoal

Slowly and carefully add the lye to the water and gently stir until the lye has fully dissolved and the liquid is clear. Set aside to cool. 

Melt the castor oil, coconut oil, olive oil, palm oil and tamanu oil (remember to fully melt the entire container of palm oil before portioning out). When the lye water and the oils have cooled to 130 degrees or below (and are ideally within 10 degrees of each other), add the lye water to the oils and stick blend until thin trace. 

Sprinkle 2 tablespoons of activated charcoal to the soap mixture distributing in a fine all over layer on top to reduce clumps. Without turning it on use your stick blender to stir the charcoal into the soap batter. Slowly pulse the stick blender to incorporate the charcoal. 

Add the tea tree essential oil to the soap, and use the stick blender to blend and stir the essential oil until completely mixed in. 

Continue to stick blend for just a few seconds, to make sure the ingredients are completely combined. When the soap is a medium trace and is still pourable, pour the batter into your soap mold. Tap the mold on the counter to even the soap and get rid of bubbles. 

Spray the top of the soap with 99% isopropyl alcohol to prevent soda ash. Place on a heating pad set to medium heat, and insulate the soap for about 30 minutes. Turn off the heating pad, and leave the soap insulated for 24 hours. 

Allow the soap to stay in the mold for at least 3-4 days. Because this soap has plenty of soft oils, it may need up to a week in the mold. Don't rush it! When the soap is firm enough, unmold and allow them to cure for 4-6 weeks.